by wavefin » Mon Dec 19, 2011 11:19 am
by jaffa1949 » Mon Dec 19, 2011 12:14 pm
by Roy Stewart » Mon Dec 19, 2011 8:35 pm
by Roy Stewart » Mon Dec 19, 2011 8:39 pm
by drowningbitbybit » Mon Dec 19, 2011 9:05 pm
by wavefin » Fri Dec 23, 2011 3:56 am
by wavefin » Sun Dec 25, 2011 11:56 pm
“All surfboard fins” create drag and friction.Roy_Stewart wrote:The main issue with that setup is that the wings will prevent the board from rolling fron rail to rail, a secondary issue is that there are two unnecessary dragt inducing fin tips, the job could be accomplished with two rather than four.
If the fins are swapped so that the wings point inwards there will be some improvement.
.
by wavefin » Mon Dec 26, 2011 12:21 am
drowningbitbybit wrote:Are they like bicycle stabilisers for surfboards?
by wavefin » Mon Dec 26, 2011 1:37 am
Roy_Stewart wrote:Another problem is that the wing area is much too far from the bottom of the board, it should be within three inches or so of the bottom of the board otherwise the handling problems will be drastically increased at speed.
9 days ago by Swimmy Tim5 comments
10 days ago by BaNZ3 comments
15 days ago by BoMan6 comments
18 days ago by hannaconner5 comments
1 month ago by BaNZ4 comments
1 month ago by HaoleKook4 comments
1 month ago by Jimgem2 comments
2 months ago by YTsurf4 comments