Page 1 of 1

PRESSURE DING BAD?

PostPosted: Fri Nov 26, 2004 3:24 pm
by MAHALO7stefen
i have a pressure ding thats about 5 inches long and like hmm maybe 4 millimeters deep only near the middle of the ding then spreads out to like 2 mm.

Image
Image
Image



the ding seems like its not going to be any problem cuz its all covered up already and not even deep. the only thing is that is kinda long. ( i got suncure just in case)

what u ppl think :O :o [/img]

PostPosted: Mon Nov 29, 2004 10:20 pm
by MAHALO7stefen
BUMPEDOO :roll: :shock: :(

PostPosted: Wed Dec 01, 2004 11:35 am
by southcoaster
think you should just leave it, just keep an eye on it, if its starting to crack then dung some of the sun cure stuff on it, but i suppose its a nice board, so suppose you could go to a shaper and he will cut it out and fill it back in but probable looking at £50 so might not be worth it, anyway thats my opinion, your choice!

update

PostPosted: Wed Dec 01, 2004 8:40 pm
by MAHALO7stefen
Image
Image
Image

instead i just put some suncure over the whole pressured area (i checked for cracks before-none i think, maybe a little crease thing u could see but it looks like there was a white smeared suncure like the end of the smear, didnt think it was a crack [dont mind what i just said im dumb lol])

neways i kind of did a newbie job :/ i still have to get 180 sandpaper grade cuz all i have now is the finest.

if u look closely on picture 3 u can see like a kinda of long small bump / hill of suncure like as if it were excess glue, im going to see if i can sand that down smooth with the other stuff. hope so :/ i dont want that chunk of suncure,

it really isnt smooth at all,can any experts tell me w/ 180 grade sandpaper if i can sand all of that down smooth ahh :oops: hope i can!

PostPosted: Sat Dec 04, 2004 9:59 pm
by southcoaster
not too bad job mate, just get some sand paper and smoth it out should be super! make it look nice and tidy,

PostPosted: Sat Dec 18, 2004 12:16 am
by Squeaky
hey soz 2 be annoying or anything but i'd just like 2 know what a pressure ding actually is and how it is caused?

PostPosted: Sat Dec 18, 2004 12:49 am
by MAHALO7stefen
its just like a dent in a car except in yur surfboard

occurs from board in contact with something not sharp or small enough to puncure but leave a crater of sort

you have some on the top of yur baords the small ones from pressure from yur feet


nehow i bought this used

there was a line of crack so i suncured over the area then sanded down

covers crack if water wants to get in, looks like im hardcore hahaha jk :wink:

PostPosted: Sat Dec 18, 2004 2:27 am
by Squeaky
ok thnx i thought it was something like that